American-lighting EP3S Series Bedienungsanleitung PDF herunterladen

WARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way.

Products should be installed in accordance with these instructions, and with current electrical codes and/or the current National

Electric Code (NEC).

WARNING: To avoid electric shock or injury to persons, disconnect power prior to installation.

Caution: Injury to persons and damage to the fixture and/or mounting surface may result if the fixture is not

properly installed. To reduce the likelihood of such injury or damage, read and follow all instructions.

Use only a mild soap and water with soft cloth to clean the fixture. Harsh chemicals will damage the finish. Do not wipe the

fixture with a rough cloth that may scratch the finish or the lens.

WARNING: Risk of fire or electric shock. Install the LED Swivel Recessed Fixture only with the 3” housing included.

WARNING: Risk of fire or electric shock. The electrical rating of this product is 120V AC. The installer must determine whether

power supply is 120V AC before installation. The driver in the housing’s junction box must not be removed.

Each 3” E-Pro LED Swivel Recessed Light Kit includes 3-3/8” (86mm) diameter cut-out template; LED light engine (EP3S has

swivel feature, EP3 is standard downlight), integrated lens, trim, heat sink, attached torsion clips to hold recessed downlight in

place and power lead wire with “A” type connector; insulating foam ring; 3” remodel style housing with power lead wire, power

junction box, drywall clips and mating “B” type connector; and these safety/ installation instructions.

INSTALLING RECESSED HOUSING:

To avoid electric shock or injury to persons, disconnect power prior to installation.

1. Determine desired location for light. NOTE: 120V AC supply power is needed in the

ceiling plenum at this location.

2. Using the cut-out template, mark the cutting line for installing the remodel housing.

3. Cut this hole from the drywall or surface material using an appropriate saw or cutting

tool and remove cut-out material. NOTE: The size of the cut-out hole is very important!

Do not exceed 3-3/8“ (86mm) in diameter! Proper installation of housing and light

engine depend upon correct sizing of cut-out.

4. Locate supply power in ceiling plenum. Pull supply wires through cut-out and strip

back conductors 3/8”. See Figure 1.

5. Push upward on the junction box closure clip to release the junction box cover.

See Figure 2.

6. Punch out the knockout that is most suited for the installation. Use UL Listed

cable clamp connector (not included) to provide strain relief for supply wires.

7. Route minimum 18AWG solid copper wires through knockout via cable connector.

Attach line voltage AC supply wires to driver lead wires inside of junction box: Black to

Black, White to White, Green or bare wire to Yellow/Green (Ground). Secure each

connection using the quick connectors provided on the

driver lead wires. See Figure 3.

8. Replace junction box cover by lining up tabs and

pressing firmly until closure clip snaps in place.

NOTE: Be sure that the wires are not pinched or

damaged by any part of the junction box or its cover.

3” E-Pro LED Recessed Kit

Installation Instructions for EP3 and EP3S Series

Figure 3 - inside junction box

Figure 1

Figure 2

Punch out knockout,

attach cable clamp

and bring supply wires

into the junction box

through the cable

clamp/knockout.

Pull supply wires

through cut-out

and strip back 3/8”.

Push up

on clip

to open.

www.americanlighting.com RV1251Page 1 of 2

CONTINUED ON REVERSE.

1 2

3” E-Pro LED Recessed Kit 1

Inhaltsverzeichnis

Seite 1 - 3” E-Pro LED Recessed Kit

WARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products should be installed in

Seite 2

Align torsion clips with housing and push trim/light engine gentely to ceiling until seated.3” E-Pro LED Recessed KitInstallation Instructions for EP3

Verwandte Modelle: EP3

Kommentare zu diesen Handbüchern

Keine Kommentare

American-lighting EP3S Series Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung American-lighting EP3S Series herunter. American Lighting EP3S Series User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: EP3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung American-lighting EP3S Series